Holex 421721 Mode D'emploi page 20

HOLEX Digital outside micrometer with offset measuring surfaces
de
1. General information
Read and observe the operating instructions, keep them as a reference for later and ensure they are accessible at
bg
all times.
1.1. SYMBOLS AND MEANS OF REPRESENTATION
da
Warning symbols
CAUTION
en
2. Safety
fi 2.1. GROUPED SAFETY MESSAGES
CAUTION
fr Leaking electrolyte
Eyes and skin irritation can occur due to leaking, poisonous and corrosive electrolytes.
▶ Avoid contact with your eyes and body.
▶ In the event of contact, rinse out the affected area immediately with plenty of water and consult a doctor.
it
2.2. INTENDED USE
 Outside micrometer for digital and analogue reading.
hr
 For both industrial and private use.
 Use only in accordance with the technical data.
 Use only when it is technically in good condition and safe to operate.
lt
2.3. REASONABLY FORESEEABLE MISUSE
 Avoid vibrations, jerky movements, shocks and impacts.
nl
 Do not use in potentially explosive atmospheres.
 Do not expose to strong magnetic fields or high voltage environments.
 Do not expose to strong heat, direct sunlight or open fire.
no
 Only open the casing at the battery cover for replacing the battery.
 Do not carry out any unauthorised modifications.
3. Transport
pl
Transport in the original packaging at temperatures between -10 °C and +60 °C. Secure against falling to the ground.
4. Device overview
pt
4.1. OUTSIDE MICROMETER
A
ro
1 Stirrup 2 Anvil with stepped measuring surface 3 Measuring spindle with stepped measuring surface 4 Clamping
lever 5 Button "ON/OFF - SET" 6 Button "ABS/INC - UNIT" 7 Scale sleeve 8 Scale drum 9 Friction ratchet 10 Quick adjust-
ment 11 Battery cover (back) 12 Adjustment hole (back) 13
sv
sions of the remote measuring surface
4.2. DISPLAY
sk
B
Digital display:
1 Low battery voltage 2 Measuring mode "Absolute" 3 Measuring mode "Incremental" 4 Zero point adjustment 5 Di-
sl
gital measured value 6 Display measuring unit
Analogue display:
es
7 0.01 mm - scale on scale drum 8 Scale for full millimetres on scale sleeve 9 Bezugslinie 10 Skala für halbe Millimeter auf
Skalenhülse 11 Reading edge
4.3. SCOPE OF SUPPLY
cs
 1x Outside micrometer
 For measuring range from 25 mm: 1x setting gauge
 1x Adjustment tool
hu
20
Meaning
Indicates a hazard which if not avoided may lead to minor or moderate injury.
Lorem ipsum
LCD display 14 Insulating plate 15 Adjustment tool 16 Dimen-