Publicité
Les langues disponibles
Les langues disponibles
LUBRICATION
All models may operate without airline lubrication. However, operating the tool without airline lubrication may reduce tool performance and vane life.
If an airline lubrication is not used, it is recommended that the tool be oiled daily before use to improve performance. Add 2-4 drops of air motor oil and run the
tool for 10-20 seconds to distribute oil through the tool.
For maximum performance and tool life, an air line lubricator, set to deliver 2 drops per minute, is recommended. SIOUX No. 288 Air Motor Oil is
recommended.
Do not over lubricate because excess oil may contaminate the surface being sanded.
MAINTENANCE
Water, dust and other airline contaminants can cause rust and vane sticking. For long periods between tool use, flush the tool with a few drops of oil and run
for 10 seconds. This will help remove contaminants and reduce the formation of rust.
OPERATION
The tool is equipped with a locking type lever in order to prevent accidental start-up.
Speed of the tool may be adjusted by turning the regulator, which is located opposite the throttle lever.
INSTALLING SANDING DISC
•
Thread backing pad onto spindle.
•
Place sanding disc over spindle and seat against backing pad.
•
Thread disc retainer onto spindle and tighten with supplied wrench.
Catalog
Number
VS40S609
VS40S807
VS40S607
Form ZCE852
WARNING
Always remove the tool from the air supply be for installing or changing sanding discs!
NOISE AND VIBRATION READINGS
Noise* (Tested in accordance with ISO Standard 15744)
*Sound Pressure
*Sound Power
(dBA)
94.4
99.4
98.0
Uncertainty (dBA)
(dBA)
105.4
3.0
110.4
3.0
109.0
3.0
3
Vibration* (Tested in accordance with
ISO Standard 28927-3:2009)
*Vibration m/s
Uncertainty m/s
2
3.6
1.28
3.78
1.38
3.6
1.28
2022June28/C
Date
2
Publicité
