Selecline 154469/DF1-06B-1 Manuel D'utilisation page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
3. Leave enough space to access and open the door easily. If necessary, change the direction of
door opening as described below.
Level feet
If the appliance tilts in some way, adjust the height of the left/right foot (5) of the appliance to
be in a horizontal level (
Turn the foot (5) clockwise or to counter clockwise to adjust the height.
Note: If the appliance is not level, the door and the door seal will not be closed properly.
Reverse Door
Ensure the appliance is unplugged and empty. To take the door off, it is necessary to tilt the
appliance backwards. You should rest the appliance on something solid so that it will not slip
during the door reversing process. All parts removed must be saved to do the reinstallation of
the door. Do not lay the appliance flat as this may damage the coolant system. It is better that
2 people handle the appliance during assembly.
1. Remove the top right hinge cover (
2. Undo the screws. Then remove the hinge bracket (
3. Remove the top left screw cover (
4. Move the core cover from left side to right side. And then lift the upper door and place it
on a padded surface to prevent it from scratching (
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it (
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet (
7. Place the door back on. Ensure the door is aligned horizontally and vertically so that the
seals are closed on all sides before finally tightening the top hinge (
8. Insert the hinge bracket and screw it to the top of the unit.
9. Use a spanner to tighten it if necessary.
10. Put the hinge cover and the screw cover back (
Install door handle
Fig. 9.
Rear spacer
Screw the rear spacers at the rear of the appliance (
Positioning
Install this appliance at a location where the ambient temperature corresponds to the climate
class indicated on the rating plate of the appliance. This ensures the correct operation of the
appliance..
Climate class
SN
N
ST
T
Fig. 11).
Fig. 1).
Fig. 3).
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
9
Fig. 2).
Fig. 4).
Fig. 7).
Fig. 8).
Fig. 10).
EN
Fig. 5).
Fig. 6).

Publicité

Table des Matières
loading

Table des Matières