ASSEMBLY INSTRUCTIONS (CONT.)
4. Attach each LEG BRACE #5 to LEGS as shown with SMALL BOLT #8 and SMALL FLAT
WASHER #9. Feed wire leads through gasket, and carefully turn table over.
5. Attach ELECTRONIC SCORER #11 with SCREW #16 and insert leads A & B from Sensor Wires #17.
Carefully attach 2 wire leads to
ELECTRONIC SCORER #11.
Insert the lead " A "
into the " A " receptacle.
Insert the lead " B "
into the " B " receptacle.
17
B
A
A
B
* Before turning the
table over, carefully
feed two wire leads
through gasket hole
in center of side panel.
5