Leviton 6616 Manuel D'installation

WARNINGS AND CAUTIONS:
• TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING!
• To be installed and/or used in accordance with electrical codes and regulations.
• If you are not sure about any part of these instructions, consult an electrician.
• DO NOT install to control a receptacle, fluorescent lighting, a motor- or a transformer-operated appliance other than appropriate ceiling fans.
• For use on ceiling paddle fans with split-capacitor or shaded pole motors only and marked as suitable for use with a solid-state fan speed control and is rated 120 volts,
5 amperes maximum. Please refer to fan manufacturer's instructions or rating labels on the motor to confirm type.
Use of any other types of motors or equipment may cause overheating and/or damage to the motors or equipment.
• Use this device with copper or copper clad wire only.
FEATURES
• Operates any number of ceiling fans up to rating limits
• Minimum Speed Adjustment
• Fits standard wall boxes
MULTI-FAN CONTROL
Any number of fans of the same type may be controlled by a single fan speed control provided that the total amperage of the fans does not exceed the amperage rating of the
fan speed control.
GANGING / DERATING
When combinations of dimmers and/or speed controls are installed in a ganged wall or outlet box, de-rating is required. When two speed controls or one dimmer and one speed
control are mounted in a ganged box, the maximum load per speed control shall not exceed 4 amps. When three or more speed controls and dimmers are mounted in a ganged box,
the maximum load per speed control shall not exceed 3 amps. Refer to the instruction sheet provided with the dimming control for the proper de-rating of that unit.
INSTALLATION
1. Remove existing wallplate and switch, if applicable.
2. Remove 5/8" (1.6 cm) of insulation from each circuit conductor. Make sure the ends of wires are straight.
3. Connect wires per appropriate WIRING DIAGRAM as follows: Twist strands of each lead tightly together and, with circuit conductors, push firmly into appropriate wire
connector. Screw connectors on clockwise making sure no bare conductors show below the wire connectors. Secure each connector with electrical tape.
NOTE: Fan speed control MUST be adjusted so that fan rotates at its slowest speed after power is restored.
4. Restore power at circuit breaker or fuse. Hold speed control securely by its insulated case, turn the control ON and rotate shaft clockwise until it stops.
5. Insert a small screwdriver into trim slot (see Figure 1) and turn counterclockwise to lower fan speed control, clockwise to increase fan speed.
6. After adjusting for minimum fan speed, turn off power at fuse or circuit breaker. Then restore power at circuit breaker or fuse. Fan should be rotating after power has been
interrupted and then restored. If fan is not rotating readjust by increasing minimum fan speed as explained in steps 5 and 6.
7. After a suitable minimum speed has been determined, turn the switch shaft counterclockwise until it clicks OFF. The minimum speed is now set.
8. TURN OFF POWER. Installation may now be completed by carefully positioning all wires to provide room in outlet box for fan speed control. Mount fan speed control into box
with mounting screws supplied. Attach wallplate and knob.
9. Restore power at circuit breaker or fuse. INSTALLATION IS COMPLETE.
Figure 1 - Fan Speed Control Functions
Figure 1 - Fonctions de la commande de vitesse de ventilateur
Figura 1 - Funciones del Control p/Velocidad de Ventilador
Wallplate
Plaque
Placa Mural
Knob
Bouton
Perilla
Note: Wallplate design and markings may vary.
Remarque: Le design et les marquages de la plaque murale pourraient varier.
Nota: El diseño de la placa de pared y las marcas dibujadas en la misma pueden variar.
FOR CANADA ONLY
For warranty information and/or product returns, residents of Canada should contact Leviton in writing at Leviton Manufacturing of Canada ULC to the attention of the
Quality Assurance Department, 165 Hymus Blvd, Pointe-Claire (Quebec), Canada H9R 1E9 or by telephone at 1 800 405-5320.
Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper
use for five years from the purchase date. Leviton's only obligation is to correct such defects by repair or replacement, at its option. For details visit www.leviton.com or call 1-800-824-3005. This warranty
excludes and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused,
opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including
merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for a
particular purpose, is limited to five years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment,
lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.
For Technical Assistance Call: 1-800-824-3005 (USA Only) or 1-800-405-5320 (Canada Only) www.leviton.com
Rotary Fan Speed Control
Single Pole (1 location)
Cat. No. 6616
Rated: 5A-120VAC, 60Hz
INSTALLATION
Schéma de câblage - Installation de la commande en emplacement unique
ON/OFF
Rotary-Button
Switch
Interrupteur rotatif
marche/arrêt
Interruptor Giratorio
ENCENDER-APAGAR
Line / Ligne / Línea
Trim Slot
120V AC/CA, 60 Hz
Fente de réglage
Ranura de Ajuste
LIMITED 5 YEAR WARRANTY AND EXCLUSIONS
Wiring Diagram - Single Location Control Application
Diagrama de Cableado - Aplicación para Control Sencillo
Fan Speed Control
Commande de vitesse de ventilateur
Control p/Velocidad de Ventilador
Hot (Black) Black
Actif (Noir) Noir
Fase (Negro) Negro
Neutral (White)
Neutre (Blanc)
Neutro (Blanco)
DI-000-06616-22D
ENGLISH
Black
Black
Noir
Noir
Negro
Negro
Fan
Ventilateur
Ventilador
Green Ground
Vert MALT
White
Verde Tierra
Blanc
Blanco