Basic Function; Radio Operation; Manual Tuning - Blaupunkt BLP8100-001 Guide D'utilisation

GENERAL OPERATION
• At standby mode, press the "STANDBY/FUNCTION" button to switch on the unit.
• Press the "STANDBY/FUNCTION" button once to switch other mode. (CD/ MP3/ USB/ AM/FM/ AUX-IN/ TAPE)
• Press and hold the "STANDBY/FUNCTION" button for 2 seconds to switch off the unit in all modes.
• Press the "VOL+" or "VOL-" button to adjust volume level.
AUTOMATIC TUNING
1 . Press the "FUNCTION" button to select "FM" mode.
2 . Press and hold the "SKIP+" or "SKIP-" button over 2 seconds to start automatic tuning process.
When a station is tuned in the tuning process, it will stop automatically and you can listen to your desired station.

MANUAL TUNING

It is for selecting stations, which cannot be tuned automatically.(manual selection)
1 . Press the "FUNCTION" button to select FM mode.
2 . Press the "SKIP+" or "SKIP-" button to select station.
Each time the "SKIP+" or "SKIP-" button is pressed momentarily the frequency changes by a fixed step: 0.05MHz.
AUTO SCAN
This product equipped auto station scan & saving function. Up to 30 stations can be saved.
1 . Press the "FUNCTION" button to select FM mode.
2 . Press and hold the "SCAN" button 2 seconds, unit will auto search and save all available radio station.
Press the "M+" or "M-" to select your preset station.
PRESET STATION
Up to 30 stations can be presented (replace the AUTO SCAN saving station)
1 . Select desired radio station by "SKIP+" or "SKIP-".
2 . Press the "MEMO" button, the display will show "P01" and flashing.
3 . Press the "M+" or "M-" button to select the preset station position.
4 . Press the "MEMO" button again to confirm desired radio station in memory.
5 . Once all the stations were preset, press the "M+" or "M-" button to listen to your desired station.
FOR BETTER RECEPTION
FM - This appliance has a FM antenna located at the rear cabinet. This wire is completely unraveled and
extended for better reception.

BASIC FUNCTION

RADIO OPERATION