Black & Decker FIRESTORM FSNS100 Manuel D'instructions page 9

639224-00 FSNS100 Stapl
A
Fig. 29
RUBBER NOSE CUSHION
A rubber nose cushion (A) Fig. 30 is provided to reduce marring of the work surface.
The rubber cushion can be removed, and stored inside the magazine (B) Fig. 31 when
it is not required.
Disconnect tool from air supply before removing or re- installing rubber
cushion.
CLEARING A JAMMED FASTENER
Disconnect tool from air supply.
1. Open magazine and remove remaining fasteners. (Fig. 32 and Fig. 33)
Remove fasteners from tool before opening the fastener guide
plate. Fasteners are under pressure and may shoot out of magazine which could
cause injury.
2. Open the quick release latch and the fastener guide plate. (Fig. 34)
3. Remove the jammed fastener. (Fig. 35)
4. Close the fastener guide plate, and the quick release latch.
12/14/05 7:25 AM Page 9
Fig. 31
9
Fig. 30
A
B