BS KA101E Mode D'emploi page 38

Procedure for fixing
I. Dimensional drawing
II. Draw the points highlighted on the wall and drill the 6 holes indicated:
o
A-A' : Holes for the engine box support
o
B-B' : Holes for the tube support
o
C-C' : Holes for safety fixing
III. Fix the hood in A-A' ; tighten the hose to the bracket B-B'; remove both filters
for definitive fixing in C-C'
Connecting and fitting
Before connecting the appliance, check the household installation.
Appliance with prefitted power cable:
trained after-sales engineer.
Installing: Do not trap the power cable and do not route it over sharp edges. If the
oven is a built-under type, route the cable on the rear corners of the oven to the
socket.
Electrical Connection
Connect the device to the mains and check the operation .

voltage , see the rating plate .

Connect adhering strictly to the relevant diagram.
1. Brown
2. Blue
3. Yellow and green
INSTALLATION
The power cable must only be replaced by a
EN/1