EAS ELECTRIC EMRH706X Guide D'utilisation page 21

Lower decorative chimney
 Fix the exhaust pipe on the hood body,
connect chimney and hood body with
2 screws 12. Connect chimney fixing
bracket and chimney with 2 screws 12.
Hook the hood body
 Hook the hood body to the bracket 20.
 Level the hood body itself.
 Remove the filter from the inside of the hood body, fix the screws 10 to Wall
Plugs 11 at the points (3).
CONNECTIONS
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to
the chimney using either a flexible or rigid pipe ɸ 150 or ɸ
120 mm, the choice of which is left to the installer.
If to install a ɸ 120 mm air exhaust connection, insert the

reducer flange 3 on the hood body outlet.
Fix the pipe 4 in position using sufficient pipe clamps

(not supplied).
Remove possible charcoal filters.

Upper Decorative Chimney
Insert the upper decorative chimney 2.2 into the lower decorative chimney 2.1

and drag it up to the horizontal line B
Connect upper decorative chimney 2.2 and chimney fixing bracket 21 with 2

screws 12 .
Right Wrong
B
8 V.4