Toolland PM 6640 Mode D'emploi page 4

HALOGEN WORKLIGHT
PM 6640
WARNING
Read this information before use.
ASSEMBLY
Do not assemble while plugged into power.
Insert stand base into other
end of tube.
Use the stand handle to
position the lamp to the
desired angle.
Insert and tighten angle
adjustment.
Lamp angle may be altered
simply by loosening the angle
adjustment knob, moving the
stand handle to bring the
lamp to the desired angle,
then tightening the angle
fixing knob.
REPLACE THE LAMP
Unscrew retaining screw on
top of lamp. This will release
the protective grid, front
surround and glass faceplate.
Lower front surround down. It
will be retained by the hinges.
To insert halogen globe:
unwrap globe, taking care
your fingers do not touch the
globe. Use wrapping to handle
the globe. Push one end of
globe into either of the
spring-loaded sockets. Locate
other end on other socket,
and release.
Carefully replace front
surround, making sure that it
is correctly positioned. Screw
up tightly.