AVS Ventvisor VV142 Instructions D'installation page 2

Installation Steps
Align the Front Visor on the outside of the door frame. The top flange of the Front Visor will attach to the door frame.
edge of door frame.
3
Gently press the exposed areas of tape against the surface and
verify position. With the Front Visor in its final position, remove the
remaining tape liner by pulling on free ends.
4
4 Piece Set
Remove tape liner from Extended Rear Visor.
free end
6
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the re-
maining tape liner by pulling on free ends.
8
NOTE: Actual application may vary slightly from illustrations.
NOTE: Align with
top flange
front flange
Apply pressure along all flanges to ensure proper adhesion of tape.
5
Align the deflector on the outside of the window frame. Align the
front of the Extended Rear Visor parallel to the previously installed
NOTE: Be sure visor does not interfere with opening the rear door.
align
7
Apply pressure along all flanges to ensure proper adhesion of tape.
Repeat Steps 1 - 9 for opposite side.
9
Page 2 of 3
Rear Visor.