Electrolux KFIA19R Notice D'utilisation page 57

1
2
2. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter
WARNING!
The charcoal filter is non-washable!
To replace the filter:
7. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
1. Remove the grease filters from the
Refer to "Cleaning the grease filter" in this
chapter.
2. Remove the clips holding the filter bed,
3. To install a new filter, perform the same
In any case, it is necessary to replace the
filters at least every four months.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
57
appliance.
then the filter bed.
1
2
steps in reverse order.
Remedy
Check if the appliance is correctly
connected to the electrical supply.