Publicité
Les langues disponibles
Les langues disponibles
10W WIRELESS CHARGER
Ref: KO032404
You have just acquired a KeyOuest brand product and we thank you for it, we hope that it will bring you complete
satisfaction.
CHARACTERISTICS
• Input: 5V
• Input current: 5V/2A
• Output: 10W
PACKAGING CONTENT
•
A wireless charger
•
A Micro USB cable
•
A user manual
WARNINGS & SAFETY INSTRUCTIONS
•
Do not short-circuit.
•
Make sure that the correct voltage is used, as prolonged excessive voltage may damage your device.
•
Do not attempt to use this power supply with any device requiring more than the rated output power.
•
Do not attempt to open the charger.
•
Remove this charger from the mains when not in use.
•
Always switch off your device before connecting/disconnecting it from the charger.
•
The power socket must be installed near the equipment and must be easily accessible.
It is also recommended to :
•
Charge your electrical or electronic devices outside of wet rooms.
•
Do not use a plugged-in electrical device, including a waterproof and water-resistant telephone, in the bathtub
or shower.
•
Do not handle a plugged-in electrical device with wet hands or feet, or with feet in water.
Guarantee
The products are guaranteed not to fail due to manufacturing defects. This warranty does not cover defects due to misuse or normal wear
and tear, so please keep your invoice attached to this guide.
This symbol means that this device is for indoor use only.
P max: 10W max.
Operational Frequency band or bands:110-205 kHz
The socket must be installed close to the equipment and must be easily accessible.
PRODUCT USE
Make sure your device is compatible with inductive charging and that wireless charging is enabled if required.
If your device has a metal protective case, remove the case before charging.
If the shell of your device is too thick, you may experience inefficient charging. Remove the case and all accessories to
receive the fastest charge.
CHARGING YOUR DEVICE
1. Connect the USB end of the charging cable to a power source (such as a wall charger) and the Micro USB end to the port
on the inductive charger. A quick charge mains charger is recommended to achieve 100% charging potential.
2. Place the charger on a solid flat surface, such as a desk or table.
3. Place your appliance directly on the corresponding induction surface.
4. Make sure the center of the device is aligned with the center of the induction charger.
5. The loading will start on contact.
Directive 2012 / 19 / EU
Correct disposal of this produt
Electronic waste should not be thrown away with household waste. Please recycle them to your authorized agency and check the recycling advice with the relevant
local authorities.
SRDi declares that the product «10W wireless charger» is in conformity with directives 2014/30/EU & 2011/65/EU.
The full EU Declaration of Conformity is available on our KeyOuest website at: www.keyouest.fr
2023/03V02/MKG
SRDi - 85430 La Boissière des Landes FRANCE
Publicité
