Reiner P1-MP2-RD Mode D'emploi page 11

3. Storage

MP ink is fast-drying. The time it takes the print head
nozzles
6
and the humidity.
- If the printing break will probably take more than 5 minutes,
the print head
- If the printing break will probably take more than 2 hours,
the print head
air-tight aluminium pouch.
Remove the print head
f
Place the print head
f
surface as shown in figure
Press the print head
f
Place the print head
f
the zip fastening completely.
Use the print head within four weeks after opening.
Fig. +
A D
to dry up depends on the ambient temperature
should be protected with the clip
4
with the clip
4
out of the device.
4
with the clip
4
down until it snaps in the clip
4
into the aluminium pouch and close
4
should be stored in the
3
on a smooth and solid
3
D
.
.
3
.
3
GB
10