JVC SE-472BK Instructions page 9

Recording with SEA Effects
Using a cassette deck connected to the SE-472BK, you can make recordings with SEA effects.
(See instructions for cassette decks.)
SEAREC 1. Press the SEA REC button to turn on the function.
m:ON
: OFF
2. Set the cassette deck to the REC standby mode.
3. Play back the source you want to record and set the cassette deck to the recording mode.
Q If the LINE OUT button is pressed for the TAPE side, you can listen to the sound which
is being recorded with SEA effects.
If the LINE-OUT button is set for the SOURCE side, the sound will be recorded with SEA
effects but you will not be able to hear the sound with effects through the speakers.
Notes:
¢ Please note that pressing the ATTENUATOR button during recording will change the
recording level.
¢ If, during recording, functions which will alter effects are put in use, such as SEA PRESET
or SEA CONTROL, sound you are recording will be affected accordingly.
| ss.
To Users of the JVC COMPU LINK Remote
Control System:
If you are using the JVC COMPU LINK Remote Control System with compatible components
for a cassette deck and amplifier connected to the SE-472BK, and also a CD player and tuner
connected to the amplifier, you will be able to perform "synchronized recording". In this mode
recording of a source will start simultaneously with its playback. You will also be able to utilize
COMPU LINK functions via each component, provided that the COMPU LINK/SYNCHRO
terminals of the cassette deck and the COMPU LINK/SYNCHRO terminals of other components
are connected by separate cables. Please note, however, that with some amplifiers it may not be
possible to play back sound with effects which are available on the SE-472BK.
When the SE-472BK is connected to amplifiers equipped with a monitor function:
You can play back and record sound effects which are available on the SE-472BK while using
COMPU LINK functions.
When the SE-472BK is connected to amplifiers equipped with adaptor terminals:
Youcan play back and record sound effects which are available on the SE-472BK while using
COMPU LINK functions.
When the SE-472BK is connected to amplifiers equipped with an REC (recording) selector
function:
When using COMPU LINK functions in this case, the source selector of the amplifier will
automatically change to the source you have selected instead of the terminals (TAPE-1) to
which the SE-472BK is connected. It will not be possible, therefore, to play back with SE-
472BK effects. In order to do this, you need to disconnect the COMPU LINK cables so that
COMPU LINK functions cannot be carried out.
() For detailed descriptions of the VC COMPU LINK Remote Control System, please refer to
instruction manuals of other components which are compatible with this particular system.
(Y The SE-472BK does not come with COMPU LINK/SYNCHRO terminals.