GE AEE24 Manuel D'utilisation Et Instructions D'installation page 10

InstaJiationInstructions
PREPARETHE AiR CONDiTiONER
(continues)
r_ Remove the shipping screws located on
the top of the case.
i
F1 Remove the ground screws from each
side of the case. Keep them inasafe
location. NOTE: Be sure to save the ground
screws. You will need them later in the
installation.
@
Slide the air conditioner from the case
by gripping the base pan handle, lifting
up on the air conditioner, and pulling
forward. Have a second person brace the
case. Do not pull or lift on the styrofoam
discharge area.
Do not
pull
area--
damage
to the
unit may
result
% FRONT
Eli Your unit may come with internal
packaging. This packaging must be
removed prior to installing the air
conditioner back into the cabinet.
R] PREPARETHE CASE
r_ Attach the top rail gasket to the bottom
of the top mounting rail.
r_ Install the top mounting rail with 4 type A
screws from the inside of the case. Press
firmly to drive the screws into the gasket
and through the top mounting rail.
Top mounting rail
D Slide each side rail onto the edge of each
according panel. The figure shows the
orientation of each accordion panel and
side retainer assembly relative to the case
from a top view of the unit.
Side
Window FillerPanel
Side Rail
Window FillerPanel
r_ Slide the left and right accordion panels
into the top and bottom mounting rails.
Top _,_ __ Top_ight
Bottom mounting ra
0