Publicité
Les langues disponibles
Les langues disponibles
WORKING HINTS FOR YOUR JIG SAW
If your jig saw becomes too hot, especially when used at low speed, set the speed to maximum
and run no Load for 2-3 minutes to cool the motor. Avoid prolonged usage at very low speeds.
GENERAL
Always use a blade suited to the material and material thickness to be cut. Always ensure the
work–piece is firmly held or clamped to prevent movement. For easier control, use low speed to
start cutting, then increase to correct speed.
Any movement of the material may affect the quality of the cut. The blade cuts on the upward
stroke and may chip the uppermost surface or face of the work piece. Ensure your uppermost
surface is a non-visible surface when your work is finished.
CUTTING LAMINATES
Use a fine tooth blade when cutting most laminates and thin wood materials. To reduce edge
chipping, clamp pieces of waste wood at both ends on both sides and cut through the waste
wood during cutting.
202099 550W JIG SAW
11. VACUUM ADAPTER (See Fig. J)
J
Mount the vaccum adapter (6) into the opening of the
base plate (7). Make sure that the plastic tip of the
vacuum connection engages into the corresponding
opening on the housing as shown in the figure.
12. FINGER PROTECTION
The finger protection is located in front of the blade
holder. Whilst working, it will help prevent accidental
contact with moving blade.
13. DUST BLOWER AIR HOLE
This is a small aperture located underneath the housing
just behind the blade guide. Ensure this is kept clean
to allow the air flow to continually blow dust away from
the cutting area.
24
SAFETY AND OPERATING MANUAL
Publicité
