Beha-Amprobe IRC-110-EUR Mode D'emploi page 10

MEASUREMENT MODE
Taking Measurements
Press and hold the power button for at least 2 seconds to turn the product
on or off (Figure 1.1).
The product will be in measurement mode upon power on. Press down on the
trigger to hold an image. Press again to return to live image (Figure 1.2). Hold the
product 12 inches (30 cm) from the target (>59 F / 15 C) and 2.4 inches (6 cm)
O O
from the target (<59 F / 15 C) for best temperature accuracy.
O O
Note: Higher Distance to Spot ratios require smaller target areas to make
accurate measurements. The Distance to Spot ratio of this product is 20:1.
Power ON / OFF HOLD
> 2 Sec.
Figure 1.1 Figure 1.2
Image Blending
UP UP UP UP UP
Figure 1.3
Blending may be adjusted for an easier interpretation between infrared
and visible images. To change the level of blending between 0 - 100%, press
down or up on the power button while in measurement mode.
6