Sioux Tools SDG10P Serie Instructions page 4

If an airline lubrication is not used, it is recommended that the tool be oiled daily before use to improve performance. Add 2-4 drops
of air motor oil and run the tool for 10-20 seconds to distribute oil through the tool.
For maximum performance and tool life, an air line lubricator, set to deliver 2 drops per minute, is recommended. SIOUX No. 288
Air Motor Oil is recommended.
MAINTENANCE
Water, dust and other airline contaminants can cause rust and vane sticking. For long periods between tool use, flush the tool with
a few drops of oil and run for 10 seconds. This will help remove contaminants and reduce the formation of rust.
OPERATION
Start the tool by depressing the trigger.
Disconnect tool from air supply before installing or removing wheel or making any adjustments
INSTALLING MOUNTED WHEELS
Insert the mounted wheel into the collet. Make sure the wheel shank and the collet size match. Do not allow the wheel to extend
beyond the collet an excessive distance.
Hold the collet body with a 9/16" (14mm) wrench and the collet nut with a 3/4" (19 mm) wrench.
Turn the collet nut to the right and firmly tighten the collet on to the wheel shank.
REMOVING MOUNTED WHEELS
To remove the mounted wheel, hold the collet body with a 9/16" (14 mm) wrench and the collet nut with a 3/4" (19 mm) wrench.
Turn the collet nut to the left and loosen the collet.
Remove the mounted wheel.
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
May 1, 2009
Murphy, North Carolina, USA
Date and place of issues
WARNING
SOUND AND VIBRATION READINGS
*Sound Pressure
Catalog No. dBA
SDG10P18 80.0
SDG10P21 80.0
*per PN8NTC1
DECLARATION OF CONFORMITY
SDG10P18 & SDG10P21
EN 792, ISO 12100-1, ISO 12100-2, ISO 8662, Pneurop PN8NTC1
following the provisions of
98/37/EC Directive.
Robert Hartman
Vice President and General Manager-Power Tools
Sioux Tools Inc
Name and position of issuer
*Sound Power *Vibration
dBA
91.6 Less than 2.5
91.6 Less than 2.5
*per PN8NTC1 *per ISO 8662
4
m/s
2
Signature of issuer