SNOWJOE sunjoe SPX220E-XT Manuel De L'opérateur page 8

Fig. 4
5. Connect one end of the garden hose to the washer water
inlet and connect the other end to the water supply
(Fig. 5-6).
m
WARNING!
The machine is not suitable for connection
to the potable water main.
Fig. 5
Fig. 6
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
6. Make sure the switch is in OFF position before plugging
into the power outlet (Fig. 7).
Fig. 7
7. Connect the pressure washer to the electrical supply
matching "SPECIFICATION" in this manual. Press the
reset button on the GFCI plug until the indicator
illuminates to make sure the washer is ready for operation
(Fig. 8).
Fig. 8
NOTE: The GFCI may need to be reset when first plugged into
the electric outlet. Press the "Reset" button until the power
light indicator on the GFCI illuminates.
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Turn the water supply tap on completely.
2. Make sure the safety lock is unengaged, then press
the trigger for a few seconds until water flow is steady.
This will allow air to escape and discharge any residual
pressure in the hose.
3. Press the ON/OFF switch to start the pressure washer.
8