Publicité
Les langues disponibles
Les langues disponibles
18. STAY ALERT. Watch what you are doing. Use common sense. Do not operate the tool
when you are tired.
19. CHECK DAMAGED PARTS. Before using the tool, a guard or any other part that is dam-
aged, these must be carefully checked to ensure that the tool will perform the intended
function properly. Check for alignment of moving parts, binding of moving parts, breakage
of parts, mounting and any other condition that may affect the tool's operation.
20. DO NOT OPERATE portable electric tools near flammable liquids or in gaseous or explo-
sive atmospheres. Motors in these tools normally spark, and the sparks may ignite fumes.
MULTIFUNCTION POWER TOOL USE
This rotary tool can be used for drilling, grinding, sanding and polishing, as well as engrav-
ing, cutting and removing rust in tight spaces or inaccessible places. The tool can be used on
most metals, glass, wood and ceramics. For the best performance and results, keep the speed
as even as possible without exercising too much pressure. As a guideline, use the tool at low
speed for all large accessories, such as polishing for example, and at high speed for smaller
accessories such as those used for engraving. For grinding and engraving, hold the tool as if it
were a pen.
MULTIFUNCTION POWER TOOL START-UP
Never start up or stop the tool if the accessory is in contact with the piece to be worked on.
Hold it firmly and press the ON/OFF switch. The tool will run continuously until the switch is
turned to the OFF position. The speed can be adjusted while the tool is running.
SPEED ADJUSTMENT
The multifunction power tool is equipped with speed control. Do not change the speed while the
tool is working. The speed switch is located on the rear of the tool. Turn it to increase or reduce
speed. Use the tool at low speed for polishing and similar operations, but use higher speed for
drilling or cutting actions.
IMPORTANT GENERAL SAFETY TIPS!
1.
The Tool should be unplugged when changing accessories.
2.
If you stall the tool, switch it off immediately.
3.
Periodically check the tightness of your collet chuck, especially during prolonged use of the
same accessory.
4.
After use, always disconnect your power tool.
5.
Do not undertake repair of the power tool yourself.
6.
Do not leave your tool unattended while switched on.
7.
Do not use or store your tool in damp or wet conditions.
USEFUL HINTS & TIPS
1.
Your rotary tool will become warm after prolonged use and so must be switched off and
allowed to cool down.
2.
To ensure smooth running, the spindle should be oiled periodically.
3.
Do not apply too much radial pressure to the accessory bits while polishing, cleaning,
sanding or grinding. By doing this you will put a strain on the spindle and adversely affect
the precision of the tool.
4.
Always work with a sensitive touch so as not to impede the efficiency of your mini tool.
5.
When drilling metal, always mark the drilling point with a centre punch first, so that your
rotary tool does not slip.
12
Publicité
