Battery Switch; Bluetooth ® Pairing - Hama KEY4ALL X2100 Mode D'emploi

5. Getting Started
Warning – Batteries
• When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries
accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Before you insert the batteries, clean the battery
contacts and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not
being used for an extended period (unless these are
being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain
toxic, environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries
from the product.
• Avoid storing, charging or using the device
in extreme temperatures and extremely low
atmospheric pressure (for example, at high
altitudes).
• Open the battery compartment. Remove the contact
breaker. Replace the battery compartment cover.

Battery switch

• Open the battery compartment, remove and properly
dispose of the dead batteries and insert 2x new AAA
batteries with the correct polarity. Close the battery
compartment.
• If the battery charge is low, the Caps Lock / Power LED
(6) begins to flash red during operation. Replace the
batteries immediately as described above.
Stand function
• Fold out the feet from beneath the keyboard (7) and
release the retaining flaps from the feet (8).
• With the retaining flaps folded out, position your tablet
between the keyboard and the retaining flaps.
• To close the stand, proceed in the reverse order.
6. Operation
Note
• The functions described in this section are only
available for Bluetooth
• Note that the maximum range for Bluetooth
metres without obstacles such as walls, people, etc.
6.1 Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
device is on and Bluetooth
• Make sure that your Bluetooth
device is visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Slide the [OFF/ON] switch (2) to the ON position to
switch on the Bluetooth
Power LED (6) emits a green light for ten seconds.
• First select one of the three Bluetooth
the following shortcut keys:
- fn + Q for the 1st Bluetooth
- fn + W for the 2nd Bluetooth
- fn + E for the 3rd Bluetooth
• The channel is selected as soon as the corresponding
Bluetooth status LED ((3), (4) or (5), depending on
®
selected channel) briefly lights up in blue.
• Press and hold the [fn + letter of the selected channel]
keys for five seconds to start the pairing process.
• When you release the shortcut key, the Bluetooth
status LED flashes blue.
• The keyboard is searching for a Bluetooth
• Open the Bluetooth
®
-capable terminal devices.
®
-capable terminal
®
is activated.
®
-capable terminal
®
devices.
®
keyboard. The Caps Lock /
®
channels using
®
channel
®
channel
®
channel
®
connection.
®
settings and wait until Hama
is 10
®
®
3