Publicité
Les langues disponibles
Les langues disponibles
Down Post Installation Instruction:
3
End Cap
- Remove the armrest end cap.
- Slide the down post assembly into the outermost
armrest channel. Do not tighten.
Top
5
Adjustment
Rod
1
2
3
4
5
5
4
3
2
1
Bottom
Adjustment
Rod
- The Top and Bottom Adjustment Rods should be
kept within one setting of eachother, i.e. If the top is
set to 4 the bottom should have a setting of 3, 4, or 5.
- Torque the screws to the values shown.
7
12.5 - 17.5 N • m
(9.2 - 12.9 ft • lb)
Locked
5mm
Unlocked
Mounting Hardware
- Torque the remaining hardware to the values shown.
- Ensure the receiver block is in the locked position.
- Reinstall the endcap from Step 3.
Rev C / June 2021
TB3 Version 3 Flip-back Armrests
8.0 - 12.0 N • m
(5.9 - 8.9 ft • lb)
4mm
5mm
10.0 - 15.0 N • m
(7.4 - 11.0 ft • lb)
Hinge Screws
4
Top
Adjustment
Rod
8 - 10"H
Down Post
Shown
4mm
Bottom
Adjustment
Rod
- Set the Top and Bottom Adjustment Rods so the
Down Post can be inserted into the Receiver Block.
- The down post should form and approximate angle
of 70° with the top of the armrest.
6
- Align the down post and receiver block so the top of
the down post is 2" to 5" away from the armrest
while maintaining the approximate 70° angle from
Step 4.
8
- Ensure the down post is secure.
- If the unit is equipped with a recline back, run the
recline and make sure the down post has full range
of motion. Adjust if necessary.
2
~70°
Down Post
Receiver
Block
~ 2" to 5"
Publicité
