Esoteric G-05 Mode D'emploi page 9

A
10MHz OUT connectors
These output 10MHz clock signals (sine wave, 0.5Vrms output
level, 50Ω output impedance).
Connect these 10MHz OUT connectors to the clock input con-
nectors of CD players, D/A converters and other digital devices
that support 0.5Vrms 10MHz input.
Use commercially-available BNC coaxial cables (with 75Ω
or 50Ω impedance) for connection.
B
POWER switch
Use this to turn the unit on and off.
When the unit is on, the power indicator blinks or stays lit
constantly.
o When the POWER switch is set to ON, the unit starts warming
the crystal oscillator (OCXO) up to its operating temperature.
The amount of time until the oscillator frequency stabilizes
depends on the temperature of the environment.
V
Set this unit's POWER switch to OFF when you do
not plan to use it for an extended amount of time.
C
Power inlet (~IN)
Connect the included AC power cord to this AC inlet.
After completing all other connections, plug the power plug
into a power outlet.
V
Use only a genuine ESOTERIC power cord. Use of
other power cords could result in fire or electric
shock.
V
Disconnect the power plug from the outlet if you
will not use the unit for a long time.
9