Publicité
Owner's Manual
Please check local building codes regarding footings, location and other requirements before beginning
construction.
Assembly instructions:
Reviewing all instructions and the appropriate information before you begin, make sure following the
step sequence carefully for successful results.
Flooring base:
A good location for the storage building is a square and level area with good drainage. The base is not
included in the kit which may need purchase separately or may construct a foundation and anchoring
system of your own. The foundation base should be 10 cm larger than the base rail of the shed
(minimum 10cm thickness concrete slab is recommended).
A strong plastic sheet (thickness: at least 150μm) should be placed under the foundation to assist in
reducing rising dampness from the soil, thus reducing condensation build up in the shed. Your storage
building must be anchored to prevent wind damage. Once secured, it is highly recommended applying
silicone along the inside of the base rail to minimize condensation.
Parts and Parts List:
Before you start, check to be sure that you have all the necessary parts for your building (refer to the
Parts List Page). Do not attempt to assemble the building if parts are missing because any building left
partially assembled may be seriously damaged by light winds.
Please tear off the safety protection layer before assembly, keep the part number label if needed.
Tools you need:
Safety must be put in the No. 1 position:
1. Select a dry and calm day for your assembly. Team works (Two or more people) are required during
the assembly. It is also recommended to finish the assembly in a day to avoid damage to the product
or missing of some small parts. Keep all small parts (screws etc.) in a bowl so they do not get lost.
2. Wearing safety gloves, eye protection and long sleeves during the assembly to prevent injury.
Pay attention to the sharp edge of some parts.
3. Children and pets are not allowed entering into the construction site.
4. Never concentrate your total weight on the roof of the building.
When using a step ladder make sure that it is safe.
Care & Maintenance:
1. Keep the shed clean with soft cloth, use water if necessary.
2. Keep the door tracks clear of dirt and other stuff that prevent them from sliding easily.
3. Clean the snow with necessary tools to make sure it is safe to enter
4. The shed is not made for living but storing stuff.
5. Please add some oil on the top and bottom door sliding channel to make door slides smoothly.
Assembly Preparation
into.
Publicité
