Publicité
Les langues disponibles
Les langues disponibles
E-13
INSTALLATION,
USAGE AND HANDLING PRECAUTIONS
Installation
Avoid
placing
the drive in
a
location
subject
to
:
-
high humidity
-
high
temperature
-
mechanical vibration
-
direct
sunlight
Operation
-
During operation,
excessive vibration
or a
sudden
jolt
to
the drive may
cause a
malfunction.
-
Avoid
exposing
the drive
to
sudden
changes
in
temperature.
This may
cause
condensation
to
collect inside the drive.
Transportation
-
Always
remove
the disc before
moving
the drive.
TROUBLESHOOTING
*
When the CD-ROM drive does
not
work with the hard disk drive in
primary
IDE
channel.
(SOLUTION)
1. Check the CD-ROM drive Master/Slave
Jumper setting.
The CD-ROM drive
must
be
set to
the Slave mode.
2. Check to be
sure
your hard disk Interface
type
is IDE
type.
3. Check
your hard disk Master/Slave
Jumper setting.
Some old-version IDE
type
hard disks
were
set to
Master
Only
mode.
In that case,
contact
your hard disk company and
change
your hard disk
jumper
setting
to master
mode.
4. If the CD-ROM drive does not work with above
methods,
you may need
a sec-
ondary
IDE card. If you
use
the
secondary
IDE
card,
you should
set
the CD-ROM
drive
jumper
to
the
master
mode if the CD-ROM drive is the first device you
are
connecting
to
the
secondary
IDE card.
*
When the CD-ROM drive does
not
install in OS/2 warp.
(SOLUTION)
1. Select NON-LISTED IDE CD.
*
CD-ROM drive is
not
present
in Windows 3.1
or
3.11
or
DOSSHELL.
(SOLUTION)
1. When the WIN
or
DOSSHELL command lines
are
present
in your
AUTOEXEC.BAT,
make
sure
that the MSCDEX.EXE command line appears before the WIN
or
the
DOSSHELL command lines.
NOTE
:
For
more
information,
consult the README.TXT file of the
supplied Setup
Diskette.
CRD-8322
eng
9/20/88
3:00
PM
Page
13
Publicité
