Publicité
Les langues disponibles
Les langues disponibles
SYSTEM SET-UP
1. Unbox the system.
NOTE: The system weighs 5 lbs.
2. Prepare the installation area being sure that there is
a sufficient amount of clear, dry and level space for
your packaging application.
3. Verify that the required Uline Portable Air Pump
electrical power receptacle is installed at the
desired machine location.
WARNING! Do not use an extension cord. Plug
directly into a properly grounded outlet.
4. Plug the main power cord into a properly rated
receptacle.
5. Inflate a bag – see Using Rapid Fill
USING RAPID FILL
WARNING! Wearing eye protection is
recommended.
WARNING! Ear protection is recommended if
device is to be used continuously for more than
a few hours.
1. Group the contents in the
box. (See Figure 4)
NOTE: Create the
largest continuous
void for the inflated
bag. (See Figure 4)
2. Select the proper size
bag and load it on the
air supply nozzle.
(See Figure 5)
3. Slide the air supply
nozzle completely into
the inflation port on the
one-way self-sealing
valve.
PAGE 4 OF 12
OPERATING INSTRUCTIONS
®
Bags.
®
BAGS
Figure 4
Figure 5
4. Place the bag on top of
the box contents.
(See Figure 6)
NOTE: Do not allow
any folds, bends or
twisting of the bag
at the tip of the air
supply nozzle.
5. Fold and hold the box
flaps closed and start
inflation. (See Figure 7)
6. Exert slight pressure on the
three flaps. Press and hold
the air fill switch as the
bag begins to inflate.
7. Continue to hold the three
box flaps closed while the
bag inflates. (See Figure 8)
8. When the bag has filled
the void in the box,
release the switch.
9. Pull the air supply nozzle
straight out without
twisting to avoid air loss.
10. Seal the box.
(See Figure 9)
1-800-295-5510
uline.com
Figure 6
Figure 7
Figure 8
Figure 9
0722 IH-10157
Publicité
