Publicité
SE1
SE2
SE3
18
(1)
English
6. Set up
IMPORTANT
Tighten the screws gradually by turns.
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you. (SE1)
(1) About 11 inches (28cm)
■ INSTALLING CUTTING ATTACHMENT GUARD
• Put the cutting attachment guard on the angle
transmission, attach it with the screws and hardware
provided. (SE2)
■ INSTALLING CUTTING HEAD (SE3)
1. While locking the gear shaft, by inserting the
supplied tool into the upper holder on the gear box,
loosen and remove the hexagon nut(left-handed)
2. Fit the line head assembly to the gear shaft over the
holders. Hand-tighten it securely.
IMPORTANT
You need not holder (B) and nut when installing the
cutting head.
Publicité
