Publicité
Les langues disponibles
Les langues disponibles
G
B
code SLI0011
TURN OFF POWER SUPPLY BEFORE
YOU INSERT THE CARD
RADIO KEYPAD PROGRAMMING
- Connect AA 3,6V lithium battery - D - cod. SLI0011.
- Remove cover - A - from control panel.
- Insert card - B - cod. ACG9448 in one of the free places.
- Turn on control panel power supply.
- Press and maintain pressed button - C -. You have 5 seconds to digit the code (min.
4 / max 9 numbers) and confirm pressing button A . You hear a "BEEP" to confirm the
record of the new code.
- Release button - C - .
- Repeat these steps for every new code to record.
- Close cover of the control panel - A -.
SIGNALS
no "BEEP"s = code to record.
1 "BEEP" = code recorded.
2 "BEEP" = if code is already present in the memory.
3 "BEEP" = after deletion of one code.
4 "BEEP" = during deleting procedure. Code not present in memory.
RADIO KEYPAD - CONNECTIONS AND PROGRAMMING
FOR SLIDER AUTOMAYTIC DOORS
Channel A
- D -
- B -
code ACG9448
5 "BEEP" = memory full (max 125 codes).
10 "BEEP" = All codes deleted.
DELETING ONE CODE
Press and maintain pressed button - C - up to obtain a permanent "BEEP".
Digit the code to delete (3 "BEEP" follows to confirm deletion).
Release button - C -.
DELETE ALL CODES
Press and maintain pressed button - C - up to when permanent BEEEP stops. (10
"BEEP"s follow to confirm total deletion).
Release button - C -.
The wireless keypad is backlit.
It turns on by pressing any key, then one can proceed to digit the code.
As long as the keyboard is lit, new impulses can be sent simply by pressing the
single key of the channel previously used.
The switch off is automatic 2 seconds after the last key is pressed.
14
- A -
- C -
Publicité
