ARIETE 4163 Mode D'emploi page 15

Place the cloth (M) underneath the steam head (L) - Fig. 9. Lay the cloth on the apposite Velcro (R).
Insert the plug into the socket, which must be earthed. The indicator light (D) will turn on, signalling the appliance is on and
the internal boiler is starting to heat up.
Make sure there is no more dust on the floor. Press the steam dispensing button (B) and run the appliance on the floor.
STEAMdelivery can be adjusted through the apposite dial (F), by rotating it from a minimum (-) to a maximum level (+).
For more delicate floors, as parquet, wood or laminate, it is advisable to adjust steam delivery at a lower level, while, for sur-
faces requiring a deeper cleaning, e.g. marble, terracotta tiles floor, tiles or stone, it is advisable to adjust at a higher level.
Warning!
Do not use the steam function without the cloth. The cloth can be purchased at Authorised Service Centres.
Use the appliance in well-lit rooms.
Warning!
Burn hazard! Do not turn the steam head upside-down during use to remove the cloth.
Unplug the appliance. Wait at least 5 minutes to allow both the steam head and the cloth to cool down.
The cloth can be removed and rinsed during use. Before removing the cloth, press the button (B) to stop steam dispensing
and unplug the appliance.
Filling the boiler during use
No special operation is necessary when the water in the tank runs out. Just unplug the machine, pull out the tank and fill it
with fresh cool water again. If the tap water is particularly hard (higher than 20°f), use a mixture of 50% tap water and 50%
demineralised water.
using accessory for cleaning carpets
The accessory must be used only to clean carpets and similar soft surfaces. Do not use on hard surfaces.
Lay the carpet attachment (O) on the floor on the flat side. Make sure the cloth is positioned underneath the steam head (L).
Position the appliance on the attachment (O) by slightly pressing (Fig. 10). The appliance is now ready for use.
After use
Remove the power cable from the socket-outlet. Empty the water tank completely so as to prevent the water from stagnat-
ing, which may form lime deposit.
Warning!
Wait at least 5 minutes so that the steam head and cloth cool down.
Remove cloth. Wrap the electrical power cord on hooks (E) - Fig. 11. Press the handle release button (P). Fold the handle
to close the appliance (Fig. 12). Position the appliance on the attachment for carpet cleaning (O). Position the motor body
vertically.
Warning!
Make the joint between steam head and motor body snap so that the appliance is stable in a vertical position.
Put the appliance in a dry place and away from the reach of children.
cleAning And mAintenAnce
Warning!
Always unplug the appliance before cleaning it. Let the appliance to cool down for a few minutes.
Warning!
Never immerse the appliance in water or other liquids.
Warning!
Check the state of the power cable of your appliance on a regular basis before using it, and if it is damaged, take it
to the service centre closest to you to have it replaced only by specialised personnel.
Do not use abrasive products for cleaning the appliance.
Do not put vinegar, decalcifying agents or other fragrant substance inside the tank; otherwise, the warranty may
be revoked.
cleaning the appliance
Clean plastic parts with a damp, non-abrasive cloth and dry them with a dry cloth.
Clean the water tank from time to time by putting fresh water in it. Rinse and empty.
For cleaning washable cloths, refer to indications on labels.
13