Publicité
Les langues disponibles
Les langues disponibles
4
EN
ENGLISH
Introduction
Thank you for purchasing a hjh OFFICE product.
Please read the following instructions carefully.
Illustrations may slightly differ from the actual execution.
For reasons of clarity, not all conceivable assembly variants can be described.
If you need more information and help, please contact us:
Tel .: +44 (0) 203 318 5230
email: service@hjh-office.co.uk
Note
First unpack all parts of the delivery and check them for possible transport damage.
Damaged or missing parts can affect the safety and function of the chair. In this case please
contact us first before proceeding with the installation.
In order to ensure an easy construction, we recommend at first to tighten all screws only partially.
Only after all screws have been inserted into their respective thread, should they be tightened.
Gas lift cap
Remove the protective cap (if present) from the trigger pin of the gas spring before installation.
This can easily be removed with two fingers.
Castors
Carpet castors (smooth running surface): If your chair has been delivered with factory supplied carpet castors,
these are only suitable for use on carpeted floors. For hard floors, such as parquet, laminate or tiled floor,
special hard floor castors are needed, which you can order from us as an accessory.
In addition, we recommend the use of a floor mat.
Multifunction castors (rubberized running surface): If your chair has been delivered with factory supplied
multifunctional castors, these are suitable for both carpeted and hard floors.
In addition, we recommend the use of a floor mat.
Warning
Use of the swivel chair only in accordance to its designated purpose.
If used improperly, e.g. as a climbing aid or using the armrests as supports when getting up,
there is a risk of accidents.
Safety information Gas spring
Never disassemble, pierce or open the gas spring yourself. The gas lift is under pressure.
Handy tips!
How to adjust your new
office chair correctly!
Publicité
