Publicité
Liens rapides
Publicité
Manuels Connexes pour Delta 25901 Serie
Sommaire des Matières pour Delta 25901 Serie
- Page 1 T E FLO N T E FLO N 7/20/06 Rev. B...
- Page 2 MAKE ANY OTHER WARRANTY OF ANY KIND, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY. Delta will replace, FREE OF CHARGE, during the warranty period, any part or finish that proves defective in material and/or workmanship under normal installation, use & service. Replacement This warranty excludes all industrial, commercial &...
- Page 3 RP43169▲ Lift Rod Finial Pomo de la barra de alzar Grain de la Tirette RP40268▲ Lift Rod Only Barra de Alzar Sólo RP43472▲ Tige de Manoeuvre Seulement Handle Assembly Ensamble de la Manija Poignée RP24097 1/4 Turn Stop RP25620▲ Parada (Tope) a un 1/4 de Rotación Set Screw Butée 1/4 de Tour Tornillo de Ajuste...
- Page 4 MAINTENANCE If faucet leaks from spout outlet–Shut off water supplies– Replace Seats and Springs (1). * If leak persists–Shut off water supplies–Replace Stem Unit Assembly (2). * RP41587 * Install stems (2) and 1/4 turn stops (3) correctly for proper Plastic Pop-Up Assembly Less Lift Rod handle rotation.
- Page 5 Position faucet (1) and gasket (2) on sink. Hand tighten nuts (3). Install handles (1). Be sure glide ring (2) is properly seated Option: If sink is uneven, use silicone under the gasket. in bottom of handle before installing. Coloque la llave (1) y el empaque (2) en el lavamanos. Instale las manijas (1).
- Page 6 Make connections to water lines. Use 1/2" IPS faucet connections (1). Brass Craft or Plumbshop supply lines are recommended. Complete step 4 or 5 for pop-up installation. Haga las conexiones a las líneas de agua. Use conexiones de llave IPS de 1/2" (1). Se recomiendan tuberías de suministro Brass Craft ó...
- Page 7 Step 3b Step 3 Step 3c Metal Pop-up Remove pivot nut (1). Install horizontal rod (2) and Apply silicone to underside of flange (1). stopper (3) as removable (4) or non-removable (5). Insert body (2) into sink. Screw flange (1) Remove stopper (1) and flange (2).
- Page 8 Remove aerator (1) using supplied wrench (2) and turn faucet handles (3) to the full on mixed position. Turn on hot and cold water supplies (4) and flush water lines for one minute. Reinstall aerator. Important: This flushes away any debris that could cause damage to internal parts.