Publicité
Les langues disponibles
Les langues disponibles
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the
water, which would have a detrimental or adverse effect on the operation
of the appliance. The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in
your area. Your local Water Authority can advise you on the hardness of
the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt
consumed based on the hardness of the water used. This is intended to
optimise and customise the level o f salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door, switch on the appliance;
2.Within 60 seconds after the appliance was switched on press the
Program for more than 5 seconds to enter the water softener setting
mode.
3.Press the Program button again to select the proper set according to
your local environment, the setting will change in the following
sequence: H1->H2->H3->H4->H5->H6;
4.
Press the Power button to end the setup mode.
WATER HARDNESS
German French
ºClarke
ºdH
ºfH
0 - 5
0 - 9
6 - 11
10 - 20
15 - 21
12 - 17
21 - 30
22 - 28
18 - 22
31 - 40
29 - 42
23 - 34
41 - 60
43 - 69
35 - 55
61 - 98
1. ºdH =. 1,25 ºClarke = 1,78ºfH = 0,178 mmol/l
Factory setting: H3
1) Every cycle with a regeneration operation consumes additional 2.0
litres of water, the energy consumption increases by 0.02 kWh and
the program extends by 4 minutes.
British
Mmol/l
0 - 6
0 - 0.94
7 - 14
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
Water softener
level
H1: Rapid Light
H2: 90 Min Light
H3: Rapid, 90 Min Light
H4: Glass Light
H5: Glass, Rapid Light
H6: Glass, 90 Min
Light
36
Regeneration
occurs every
X program
sequence 1)
No regeneration
10
5
3
2
1
Salt
consumption
(gram/cycle)
0
9
12
20
30
60
V.1
Publicité
