Publicité
Les langues disponibles
Les langues disponibles
Important Safety Instructions
WARNING: To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS:
1. For INDOOR USE ONLY.
2. Do NOT touch LEDs.
3. Do NOT remove the protective clear LED lens.
4. Do NOT look directly at lighted LEDs for any length of time.
5. Do NOT touch, operate, or install fixture while in contact with water.
6. Not intended for illumination of aquariums.
7. Not intended for recessed installation in ceilings or soffits.
8. Do NOT mount over sinks or stoves.
9. Do NOT mount the light to cabinets having a material thickness less
than 1/4 in.
10. Do NOT install the fixture inside of enclosed cabinets.
11. Electrical requirements:120 V AC, 60 Hz, 0.15 A MAX.
12. Do not leave bare wires exposed outside of the electrical compartment.
SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO THE FIXTURE TO
REFER TO THEM AT A LATER TIME.
Dimmer Instructions
THIS FIXTURE IS DIMMABLE BY SPECIFIC FORWARD PHASE ELECTRONIC
(TRAIC) DIMMERS. Dimmers tested to be compatible with this fixture are
the Lutron: Diva® C*L™: DVWCL-153P* or DVCL-153P*, Lumea® C*L™:
LGCL-153P*, and Toggler® C*L™: TGCL-153P*. Not recommended for use
with motion or light sensors, timers, or any other external controls.
Direct Wire Installation
Disconnect power to the electrical box and remove the old fixture. If more than two
wire leads are present, keep track of which wires were connected together.
1
Fig. 1
2
Fig. 2
Fig. 3
3
Fig. 4
4
Fig. 5
5
Fig. 6
6
Remove the diffuser by pulling back and up on the top
edge (Fig. 1).
To open the wire compartment cover, disengage both
chassis locking tabs by pushing in the side of wire
compartment cover (Fig. 2) and lifting it up to expose
DD
the wire connections and hardware kit inside (Fig. 3).
Mark the general area to install the fixture. Locate the
mounting keyhole slots on the back of the fixture. Mark
the corresponding placement on the mounting surface
(Fig. 4).
Use an awl or nail to dimple the screw holes or drill a
1/16 in. pilot hole into the marked locations. Tighten the
screws leaving 1/2 in. of the screw protruding from the
surface (Fig. 5).
Determine which corresponding knock-out is closest to
the supply wire feed and remove it. CAREFULLY
REMOVE THE KNOCK-OUT BY HAMMERING IT WITH A
FLATHEAD SCREWDRIVER OR PUNCH UNTIL THE
SURFACE BREAKS (Fig. 6). If the knock-out does not
break free, use pliers and bend it back and forth until it
snaps off.
Attach the strain relief by inserting the threaded end
Fig. 7
through the knock-out (Fig. 7). Secure the strain relief
to the fixture by tightening the fastener to the threaded
tube. NOTE: Remember to have the strain relief screws
oriented in a manner that allows tightening/loosening
of the clamp after the fixture has been attached to the
mounting surface.
- 2 -
Publicité
