HUANUO HNCM9 Manuel D'instructions page 4

Install the Pole to the Desktop
Step 1
Option A: Desk Clamp Install
1. Install the "C"-Clamp Brace(c) to the Pole (a) using 3pcs M5x14
Bolts(f), and tighten using the Allen Key(o), see Figure 1.
2. C-clamp (b) was mounted on the Clamp assembly according to the
thickness of the table top. Thickness can be changed to three
positions. Respectively,1: 11-74 mm(0.43"-2.95");2: 26-89
mm(1"-3.5");
3: 41-104 mm(1.6"-4").
Use 2 M8x12 bolts (g) and tighten them with an Allen wrench (o), see
Figure 2.
3. Use plastic knob to tighten C-clamp to the table, see Figure 3.
1
Figure 2
Option B: Grommet Base Install
Existing Grommet Hole Installation
If the existing grommet hole comes with
a plastic protector, remove it to ensure a
flat surface before installing the desk
mount.
1. Install the Grommet Base Plate(m) to
the Pole(a) using 3pcs M5x14 Bolts(f),
and tighten using the Allen Key(o), see
Figure 4.
2. Position the Pole(a) on the mounting
surface and secure using the Support
Plate (j), M10 Washer(k), Spring
Washer(l) and plastic knob. Fasten the
plastic knob using provided Wrench(p),
see Figure 5.
2 3
Phillips Screwdriver
3
f
o
Figure 1
b
Plastic Knob
Figure 3
f
w2
Figure 4
l
Figure 5
a
c
w1
g
o
a
m
o
j
k