ambiance AMB05012 Instructions page 5

Settings
1. HEAT SWING : Hold + and - under the "HEAT" mode for 3 secs to enter the Interface of
Swing setting (in 0.2-2); Press + or - to set the desired value, then press
2. COOL SWING : Hold +and- under the 'COOL" mode for 3 secs to enter the Interface of
Swing setting (in 0.2-2); Press + or - to set the desired value, then press
3. Calibrate the temperature: Hold + and – under the "OFF" mode for 3 secs to enter the
interface of temperature calibration "CAL' (in -3-+3); Press + or - to set the desired value,
then press to confirm.
Reset
Press RESET on the front case for 3 secs to restore the factory defaults
Receiver Operation (By press MANUAL to switch the receiver operation mode)
1. Manual mode: Press MANUAL once, the green light will be on (Manual mode), press M/A can
control the Relay ON/OFF. (ON: red lights on, OFF: red lights off).
2. AUTO mode: Press MANUAL again, the green light will be off (Auto mode), the ON/OFF will
be controlled by the transmitter.
LEARN CODE
1. Under the AUTO running mode, press M/Aon the receiver for 10 secs to enter this mode, the
green light will be flashing.
2. Remove the back cover of the transmitter, hold the LEARN button on the PCB board for 3
secs, the receiver green light stops flashing when it received the signals. Then the thermostat
is paired and the transmitter can control ON/OFF to the receiver now.
ON/OFF button on the receiver
O : OFF
When there is no need to use the thermostat for soma seasons, the users can just turn OFF (by the
left side of the receiver}
the power of the receiver and does not need to move off the front case;
I : ON
The receiver is normal operating.
to confirm.
to confirm.