SKINERA H3230 Instructions D'utilisation page 13

When the device is turned on, the energy level is set to level 1 automatically.
Only one energy level indicator light will be on.
To change the energy level, press the control button (#3 in the diagram)
repeatedly to increase the energy level from 1 to 5. Once at level 5, press the
control button again to reduce the energy level from 5 back to 1.
M
To determine the right energy level for your treatment area, refer
to section "9.1 Before your first treatment".
8.3 Pulsing and gliding
Pulsing is the best technique for working at higher energy levels.
Work in rows (either across or down as shown in the image). Start at one end
of each row and progress to the other end. Press the treatment surface against
your skin. The treatment surface creates temporary pressure marks on the
treated area so you can see areas you have treated. After each pulse, move the
treatment surface to the next area. Keep doing this pulsing action for the area
you are treating. Avoid gaps or overlaps between areas.
E
Do not treat the same area of skin more than once per hair removal
session.
Gliding is the best technique for working at lower energy levels.
Press the device firmly against your skin and slowly glide over your skin (either
across or down as shown in the image). Make sure that the skin is always
touching the device. At lower energy levels, the device takes only 1-1.5 seconds
to recharge between pulses. This generates a nonstop sequence of flashes.
Glide at a speed so that you avoid gaps or overlaps.
E
Stop use immediately if your skin blisters or burns.
11
EN