Replacing The Carbon Filter - Dirt Devil AC150 Mode D'emploi

4.2 Replacing the carbon filter

7
8
9
10
1. Make sure that the plug has been disconnected from the mains
socket.
2. Push the release catches on the front panel (Fig. 7).
Carefully remove the front panel.
3. Remove the used carbon filter from the HEPA filter (Fig. 8).
CAUTION:
The carbon filter cannot be cleaned. It can only be replaced (for
ordering details see chapter 5.3, „Accessories and spare parts").
NOTE:
Dispose of the used filter with the domestic waste.
4. Unpack the new carbon filter.
5. Fit the new carbon filter to the hook and eye fasteners on the
HEPA filter.
NOTE:
It does not matter which way round you attach the new filter.
However, as soon as the filter has been used, you can no longer
turn it round as dirt would otherwise get into the HEPA filter.
6. Place the front panel in the recesses in the bases of the appli-
ance (Fig. 9/arrows).
7. Then push down the front panel (Fig. 10) until you hear and see
the release catches click into place.
27