Storage; Warranty Conditions - IBEA AT48 Manuel D'instruction

Respect all of the previously described maintenance norms.
Clean the accessory carefully and grease the metallic parts.
Bush cutter: Empty the fuel tank and run the motor until the
residual fuel has been consumed. Store the machine in a dry
place.
Remove the sparkplug, pour a small amount of oil into the
cylinder, use the starter to turn the motor shaft a few times
to distribute the oil and then reinstall the sparkplug.
Hedge trimmer accessory: Clean and lubricate the blades.
Check the amount of grease present within the reducers.
This accessory has been designed and manufactured using the most modern manufacturing techniques; the
Manufacturer guarantees its products for a period of 24 months from the date of purchase, with the exception of
products for continuous professional use employed for contract work, which are guaranteed for 12 months from the
date of purchase.

WARRANTY CONDITIONS

1) The warranty is valid starting from the date of purchase. The Manufacturer shall replace any parts resulting
defective due to material, processing or manufacturing defects. The warranty does not foresee the possibility of
replacing the machine.
2) Technical personnel shall intervene as soon as possible within the time frames rendered available based on
organisational requirements. Any eventual delays shall not preclude compensation for damages nor extensions of
the warranty period.
3) In order to request warranty based assistance, authorised personnel must be shown the warranty certificate,
which has been stamped by the distributor and duly filled out in all of its parts, as well as a purchase invoice,
receipt or other compulsory document which clearly exhibits the date of purchase.
4) The warranty shall be retained void in the following cases:
- Apparent lack of maintenance
- Improper use of the product or tampering
- Use of unsuitable lubricants
- Use of non original spare parts or accessories
- Interventions performed by unauthorised personnel
5) The Manufacturer hereby excludes from the warranty all parts which are subject to normal wear and tear during
function: cutting devices.
6) The warranty shall be retained void in the case that any eventual damages resulting from transport are not
immediately signalled to the courier.
7) If any malfunctions or breakages should occur during or after the warranty period, the customer shall have no
right to suspend payment nor the right to any price discounts.
8) The Manufacturer shall bear no responsibility for any direct or indirect damages caused to people or property
resulting from machine malfunctions or resulting from its forced and prolonged suspension of use.
MOD. HEDGE TRIMMER
S.N. Nr. EXTENSION 750mm
DISTRIBUTOR:
DATE :
PURCHASED BY MR. / MRS. :
.........................

8. STORAGE

Pruner accessory: Empty the chain lubrication oil tank.
Loosen the chain's tension slightly. Apply the chain protection.
Tiller accessory: Clean the accessory before storing it: Do
not use pressure washers for cleaning.
Store it in a dry place.
ATTENTION: All of the maintenance operations which are
not described in this manual must be performed by an
authorised repair centre.
9. WARRANTY
PRUNER
EXTENSION 1500mm
41
GB
ENGLISH
TILLER
BRUSHCUTTER