Télécharger Imprimer la page

Blackstone 1841 Manuel Du Propriétaire page 11

Masquer les pouces Voir aussi pour 1841:

Publicité

Les langues disponibles

Les langues disponibles

Model 1841
troUBLESHootInG
S t E P 0 3
With the help of
Section 01
another person, set the griddle
BAT TERY POWERED IGNITION
body on its feet.
Hook the propane tank hanger on
the left leg assembly, and use one (1)
M6x70 bolt and one (1) M6 nut to
SYMPTOMS
secure it.
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
S t E P 0 4
Install the four (4) control knobs by pushing them into place in
the OFF position. Insert one (1) AA battery (not included) under the igni-
tion button.
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Ignitor wire misaligned.
04. Damage to the ignition system.
S t E P 0 5
Use one (1) M6x12 screw
and (2) washers to install the paper
If you CAN NOT ignite your griddle with a match
towel holder onto the paper towel
POSSIBLE CAUSES
bracket peg.
05. Burner tubes are not receiving fuel.
SOLUTION
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
Contact customer service for replace-
ment parts.
SOLUTION
Please reference the Gas Flow section of
the Troubleshooting Chapter.
troubleshooting
Assembly Guide
| Owner's Manual
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
3-7mm
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
07

Publicité

loading