Publicité
Liens rapides
Large Fixed, Tilt, & Extend TV Mount
RED120FTE64
INSTRUCTION MANUAL
MANUAL DE INSTRUCCIONES
MANUEL DʼINSTRUCTIONS
!
CAUTION:
THE MAXIMUM LOADING WEIGHT
IS 120 LBS. USE WITH PRODUCTS HEAVIER THAN
THE MAXIMUM WEIGHT INDICATED MAY RESULT IN
INSTABILITY AND POSSIBLE PERSONAL INJURY.
Max Screen Size: 90"
V1
P1
Publicité
Manuels Connexes pour RED ATOM RED120FTE64
Sommaire des Matières pour RED ATOM RED120FTE64
- Page 1 Large Fixed, Tilt, & Extend TV Mount RED120FTE64 INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES MANUEL DʼINSTRUCTIONS CAUTION: THE MAXIMUM LOADING WEIGHT IS 120 LBS. USE WITH PRODUCTS HEAVIER THAN THE MAXIMUM WEIGHT INDICATED MAY RESULT IN INSTABILITY AND POSSIBLE PERSONAL INJURY.
- Page 2 DISCLAIMER – WARNING INFORMATION Disclaimer –. RED ATOM has extended every effort to ensure to accuracy and completeness of this manual. However, RED ATOM does not claim that the information covers all installation and or operational variables. The information contained in this document is subject to change without notice or obligation of any kind. Regarding the information contained herein, RED ATOM makes no representation of warranty, expressed or implied, and assumes no responsibility for accuracy, sufficiency, or completeness of the information contained in this document.
- Page 3 HARDWARE PRODUCT NUMBER M4 x 12 M6 x 15 M8 x 15 M4 x 30 M6 x 30 M8 x 30 SQUARE WASHER M8 x 50 LAG BOLT 10mm 8mm x 65mm WALL ANCHOR STEEL WASHER SPACER SPACER STEEL WASHER LAG BOLT PRODUCT COMPONENT PARTS VESA Mounting Pattern (W x H)
- Page 4 IMPORTANT: BEFORE INSTALLING VERTICAL RAILS TO TV BACK When VESA pattern is larger than 200m x 200mm, the vertical rails should be attached to the TV with tension handles facing out as shown. When VESA pattern is 200mm x 200mm or smaller, the vertical rails should be attached to TV with tension handles inside as shown.
- Page 5 STEP 1A - FLAT BACK FLAT PANEL (UNIVERSAL VERTICAL RAILS) Connect Universal Vertical Rails to flat panel Conecte los rieles verticales universales a la pantalla plana Fixez les rails verticaux universels sur l’écran plat STEP 1B - CURVED BACK FLAT PANEL (UNIVERSAL VERTICAL RAILS) Connect Universal Vertical Rails to flat panel Conecte los rieles verticales universales a la pantalla plana Fixez les rails verticaux universels sur l’écran plat...
- Page 6 STEP 1- USE M8 STEEL WASHER IF THE PHILLIPS SCREWS FROM THE MONITOR KIT ARE TOO LONG Diagrams show two options for using additional washers if hardware screws are too long to properly tighten into back of flat panel television. Select the proper spacers or spacer suit as below if necessary...
- Page 7 STEP 2A- WOOD STUD INSTALLATION (CONCRETE INSTALLATION SKIP TO STEP 3) Find stud and mark edge and center locations Encuentre el poste de madera y marque la ubicación de los bordes y el centro Trouvez les emplacements des montants et marquez les bords et les centres WOOD DRILL BIT LEVEL TEMPLATE WITH NOT INCLUDED...
- Page 8 STEP 2C – DRILL PILOT HOLE AND MOUNT WALL PLATE Mount wall plate Drill Pilot Hole Secure lag bolts with steel washer to wall plate. STEP 3A - SOLID CONCRETE INSTALLATION Use wall plate to mark mounting locations/ drill pilot holes Utilice la placa de pared para marcar los orificios a la altura deseada / taladre los orificios guía Utilisez une plaque murale pour marquer les emplacements de montage/percer les trous de référence Level...
- Page 9 STEP 3B- USE TEMPLATE TO MARK WALL FOR PILOT HOLES STEP 3C – DRILL PILOT HOLES AND MOUNT WALL PLATE Drill Pilot Hole Mount wall plate Concrete Wall Insert wall Anchors gently into concrete wall with hammer if necessary Concrete Wall Hammer...
- Page 10 STEP 4A- ATTACH PANELTO WALL PLATE & ADJUST TILT ANGLE Tighten screws after attaching TV with vertical rails to the wall plate. STEP 5 - ADJUST TILT TENSION/ POST INSTALLATION LEVEL Maximum leveling adjustment 0.5”...
- Page 11 STEP 6- ATTACH PANELTO WALL PLATE & ADJUST TILT ANGLE a) Rotate handle clockwise as far as possible. b) Pull handle to side laterally (against spring tension) and rotate counter-clockwise as far as possible. c) Repeat steps a) and b) until TV holds desired tilt. OPTIONAL- DUAL ARM CAN BE EXTENDED FROM 2”...
- Page 12 Para obtener el servicio de garantía, comuníquese con el servicio de Atención al cliente de RED ATOM. Escribanos an info@redatomproducts.com. Deberá proporcionar el recibo original. Si fuera necesario enviar el producto a RED ATOM para revisarlo, los gastos de envío correrán por su cuenta. El producto de reemplazo que se le envíe se le devolverá con los gastos de envío pagos.