Tooland DT20005N Mode D'emploi page 5

6. Spraying Chemicals
This sprayer is intended for use with water-based solutions of proprietary insecticides,
fungicides, weed killers and foliar feeds. Always follow the chemical suppliers on-pack
instructions as well as the instructions listed below.
•
Wear protective clothing, goggles, face mask and gloves.
•
Avoid inhaling spray mist.
•
Avoid skin contact with chemicals.
•
Work in a well-ventilated area.
•
Take care to protect children, pets, and fish from exposure to chemicals.
•
Wash hands thoroughly after use and especially before eating.
•
Wash any contaminated clothing.
•
Seek medical attention if spray gets in your eyes or if you develop any symptoms after
spraying.
•
Do not spray near food or food preparation areas. When spraying crops, pay particular
attention to the chemical manufacturer's advice on time before crops can be eaten, etc.
•
Do not spray any solvent-based material e.g. white spirit.
•
Spray only thin watery solutions, thicker mixtures will clog the nozzle.
•
Powdered chemicals can be sprayed successfully if they are not completely soluble and the
solution tends to settle, spraying can still be successful so long as the mixture continually
agitated.
•
If the material to be sprayed contains sediment, strain the liquid into the sprayer bottle.
•
Do not over-pressurize the bottle, or tamper with the pressure release valve.
•
After use pay particular attention to the paragraph on cleaning.
•
Your sprayer is manufactured from many different types of plastic material, and although
the liquid you wish to use may be packed in a plastic container, this is no guarantee that it
will not damage the sprayer. If you are in any doubt about any chemical you intend to
spray we recommend that you contact the consumer service department at the address
given the check its suitability.
7. Maintenance
Pressure Release Valve
•
The safety valve is designed to release any excess pressure and to let you release the
pressure after spraying.
•
Do not interfere with the setting of the air pressure safety valve.
Plunger Head
•
The O-Ring should be kept lubricated to slide freely in the barrel and so pump air
efficiently.
•
To apply grease proceeds as follows.
•
Remove the pumps assembly by unscrewing in an anti-clockwise direction.
•
Locate the pump handle into the carrying position and grip the barrel.
•
Unscrew the plunger retaining cap from the pump barrel by rotating the handle.
•
Withdraw the plunger and apply silicone grease to the O-Ring.
•
When re-assembling ensure the O-Ring is not trapped between the outer edge of the
plunger moulding and the inside of the pump barrel.
V. 01 – 18/10/2021
All manuals and user guides at all-guidesbox.com
DT20005N
5 ©Velleman Group nv