Publicité
Les langues disponibles
Les langues disponibles
13. The pressing cushion is a fabric covered pad used for pressing gathered or
contoured areas such as sleeves, darts, and yokes.
14. A plastic water spray bottle is used for dampening fabric before pressing.
15. A water container is used for filling the Water Tank.
The multiple function safety features of this appliance turn off electric power to
the heater when the pressing plate has been left against the ironing board for
about 10 seconds. If the pressing plate is left in the open (up) position without
use after approximately 15 minutes, the unit will be automatically shut off. In
either case, to restore the unit, you have to press the *POWER* button again.
The following information is provided for service by a qualified electrician only:
Rated voltage: 120V~, 60Hz, 1350W
WARNING: This appliance must be grounded. Use only the proper type outlet
when plugging in the appliance. Do not attempt to override the ground wire
feature.
STEAM PRESS OPERATION
STEP 1: PREPARATION FOR USE
Set the steam press on a sturdy work surface. Unlock the locking knob.
STEP 2: FILLING THE WATER TANK
BEFORE PLUGGING IN THE APPLIANCE, FILL THE WATER TANK
a.
Always make sure the appliance is unplugged before filling the tank.
b. Fill the water tank with the pressing plate lifted to the raised (up) position.
Slide the water tank towards the front of the unit. It will not come completely
out so do not force it to do so. Using the water container, slowly pour the
water (distilled if available) into the water tank fill holes (C).
c.
Be careful to avoid spilling water onto the steam press when filling.
d. Slide the Water Tank back into its recessed position.
220-240V, 50Hz, 1350W
06
Publicité
