Publicité
5.1ch Home Cinema Package
Supplied Accessories
Make sure you have the following accessories.
Front speaker (SKF-558)
(White)
Front speakers
Speaker cables 3.0 m
20 thin rubber stoppers
*1
8 thick rubber stoppers
(For Front/Center/
Surround speakers)
Surround speakers)
*1
Configuration of the rubber stoppers may be different from the
figure, such as being 2 sheets instead of 1 sheet, but the total
number will be same.
Center speaker (SKC-391/SKC-391C)
Center speaker
Speaker cable 3.0 m
SKC-391
(European and Australian)
SKC-391C (Asian)
HTP-558
E
n
Surround speaker (SKR-558)
Surround speakers
Powered subwoofer (SKW-558)
(Red)
*1
(For Front/
Subwoofer
4 floor pads
Part Names
(Green)
(Blue)
(Gray)
Speaker cables 8.0 m
RCA cable 3.0 m
Keyhole slot
Speaker terminals
SKF-558/SKR-558
En-1
Speaker terminals
SKC-391/
SKC-391C
Keyhole slots
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
STATUS INDICATOR
Off: Subwoofer in standby mode
or disconnected from power
source
Blue: Subwoofer on
With the Auto Standby function,
the SKW-558 automatically turns
on when an input signal is detected
in standby mode. When there's no
input signal for a while, the SKW-
SKW-558
558 automatically enters standby
To AC outlet
mode.
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be
connected to the subwoofer pre
out on your AV receiver with
supplied RCA cable.
Note
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.
Publicité
