Ryobi RY25PHEMC Manuel D'utilisation page 10

WARNING:
Extreme care must be taken when using blades to ensure
safe operation. Read the safety information for safe op-
eration when using a blade and refer to the safety rules
and instructions in your attachment manual.
NOTICE:
Always operate your product in compliance with all ap-
plicable laws and ordinances.
STARTING AND STOPPING
See Figures 6 - 8.
Power head should be on a flat, bare surface for starting.
To start a cold engine:
 Lay the product on a flat, bare surface.
 Push the primer bulb approximately ten times.
 Set the choke lever to FULL CHOKE.
 Depress lock-out button and squeeze throttle trigger fully
(thru step 7) and pull starter grip and rope sharply until
engine attempts to start (no more than 4x).
 Set the choke lever to HALF CHOKE.
Normal maintenance, replacement or repair of emission con-
trol devices and systems may be performed by any qualified
repair establishment or individual with original or equivalent
parts. Warranty and recall repairs must be performed by an
authorized service center; please contact customer service
for assistance.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from spark
plug. Failure to follow these instructions can result in
serious personal injury or property damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Head protection may also be required depending on the
type of attachment used and as prescribed in the attach-
ment's Operator's Manual. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
OPERATION
 Pull starter grip and rope until engine runs, no more than
6 pulls.
 Set the choke lever to RUN.
NOTE: In cooler environments, additional pulls of the
starter handle may be required with the choke lever in
the FULL CHOKE position.
To Start a Warm Engine:
 Lay the product on a flat, bare surface.
 Push the primer bulb up to eight times.
 Set the choke lever to RUN.
 Depress lock-out button and squeeze throttle trigger fully,
pull the starter cord.
NOTE: If the product does not start, repeat the previous
steps.
To stop the engine:
 To stop the engine, depress the STOP switch to the stop
position "
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-525-2579
MAINTENANCE
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Use of any other parts could create
a hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced. Please contact customer service or a qualified
service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, lubricant, grease, etc.
8 — English
".