Sinbo SFH 3326 Mode D'emploi page 9

All manuals and user guides at all-guides.com
IMPORTANT SAFEGUARDS
agent who should be contacted if there is an oil leakage.
21. Regulations concerning the disposal of oil when scrapping the appliance have to be followed.
22. The heater should not be used in a room, of which the floor area is less than 5 M2.
23. The cord shouldn't be placed nearby the hot surface of the appliance.
24. This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
SPECIFICATIONS
1. Temperature knob
2. Power selector
3. Carry handle
4. Switch of PTC
5. Fan
6. Cord storage
7. Radiant fins
8. Castor
• 3 heat setting: 800W/1200W/2000W
• Turbo: + 400W
• 11 fins
• Adjustable thermostat
• Wheels for convenient moving
• High temperature protection system
• Cord storage
• Integrate handle
• Mounted on castors
• 230V~, 50Hz, 2000W
ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them before operating the heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright position (feet
on the bottom, controls on the top), any other position could create a hazardous situation.
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not
fall.
2. Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped bolt to the U-facing
flange between first and second fins (near the front cover).
3. To attach the castor mounting plate to the radiator body, you should insert the threaded ends of the
U bolt in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: Do not over tighten, which may cause the damage of radiator flange.
1
2
3
4
5
6
- 8 -
7
8