Publicité
GB
Thank you for the faith you have shown in us by choosing
a REHOBOT product. REHOBOT stands for products of high
quality and it is our hope that you will be able to use this
product for many years.
To avoid functional disturbances, we recommend that you
read these instructions thoroughly before using the pro-
duct.
Technical description
Hydraulic spring compressor tool designed for use together
with exchangeable jaws.
Max. working pressure: 70 MPa (700 bar, 10150 psi)
Max. load:
23 kN (2.3 ton)
Compression length:
Overall tool length (max.):
Overall tool length (min.):
Weight (Jaws not included):
The tool is equipped with a quick coupling for easy connec-
tion to a hydraulic pump.
The tool is has a bracket (A), which makes it easy to fasten
in a vice in various angles.
For safe use it is important to use jaws suited for the spring
that shall be compressed.
Designation
Spring diameter
KL-1500SP
70 - 100 mm
KL-1510SP
80 - 165 mm
KL-1520SP
155 - 195 mm
REHOBOT Hydraulics AB
250 mm (9.8 in)
731 mm (28.8 in)
481 mm (18.9 in)
8,0 kg (17.6 lbs)
Skjulstagatan 11 A, 632 29 Eskilstuna, SWEDEN P.O. Box 1107 631 80 Eskilstuna
T. +46 (0)16 - 16 82 00 F. +46 (0)16 - 13 93 16 info@rehobot.se www.rehobot.se
System construction
Always plan a hydraulic system by choosing products that
are suitable for the task in hand. Check product limitations
regarding pressure range, lifting capacity and compatibility.
The maximum working pressure of the system must not ex-
ceed the maximum working pressure of any product in the
system.
Make sure that all hydraulic hoses, connections, etc., are
connected to the right connection port (pressure or return
port) on the pump, ram, valve or other hydraulic component.
assembly of jaws
1. Place the jaw on the tool
2. Press the spring-loaded pin
3. Lock the jaw in place with the securing plate
Removal of jaws is made in the reverse order.
1
2
3
Publicité
