Beko ATP 6100 I Manuel D'instructions page 11

To Operate Your Air Purifier
7
1. Connect the appliance with power source,
one "Bi" can be heard.
2. Touch the Power button once, "Bi-Bi" can
be heard, the appliance starts to run under
under the default "AUTO" setting, its corre-
sponding indicator will illuminate, and the air
quality indicator will illuminate in blue, pink or
red according to the actual air quality.
- Very good air quality: The air quality indi-
cator illuminates in blue.
- Good air quality: The air quality indicator
illuminates in pink.
- Bad air quality: The air purifier illuminates
in red.
NOTE: Hold and Touch the "Power
C
button" for 2 seconds if you want
to enter into the sleep mode. To re-
cover, hold and Touch the "Power
button" for 2 seconds again.
Fig.5
Air purifier/ Instruction Manual
Air purifier/ Instruction Manual
Filter change
indicator
3. And you can select your required speed set-
ting by following the operation described in
"CONTROLS INTRODUCTION". After select,
the corresponding indicator of selected speed
setting will turn on.
4. After turn on the air purifier and select your
required speed setting, you can activate the
timer by following the operation as below:
Touch down Timer button on the control
panel, one beep "Bi" can be heard. There are
3 settings including 2H, 4H and 8H for selec-
tion. After select your required timing, the
indicator of selected timing will illuminate.
When the timer expires, the air purifier will
power off automatically and the indicator of
selected timing will extinguish.
5. When the filter change indicator illumi-
nates in white, it is time to change the HEPA
filter. Please change the HEPA filter by follow-
ing the operation described in the section of
"CHANGE THE HEPA FILTER".
11 / EN
11 / 120 EN