Télécharger Imprimer la page

ETNA KCS6178NF Mode D'emploi page 47

Masquer les pouces Voir aussi pour KCS6178NF:

Publicité

Les langues disponibles

Les langues disponibles

FAULTS
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
The refrigerator emits a slight
odour when used for the first
time.
The appliance does nothing;
the lighting is not lit.
Temperature inside
refrigerator too high or too
low.
Water runs from the
refrigerator.
Appliance makes a noise.
The LED lighting does not
work.
Ice building up.
Possible cause
New appliance.
Plug not in socket.
Thermostat setting incorrect.
The door seals are dirty or the
seals are damaged.
Defrost water drain clogged.
Incorrect positioning of food
in the refrigerator (or freezer).
There is an object against the
appliance.
LED lamp faulty.
Freezer compartment door not
closed properly.
The door seals are dirty or the
seals are damaged.
Solution
This is normal and disappears
when the appliance starts
cooling.
Insert the plug in the socket.
Adjust the thermostat
properly.
Clean the door seals. Call
the service centre if the door
seals are damaged.
Clean defrost water drain (see
"Defrost").
Place foods in the proper
manner in the refrigerator or
freezer.
Remove the object.
Consult a service technician
about LED lighting that is not
working. For safety reasons,
you are not allowed to repair
LED lighting yourself.
This product contains a light
source of energy efficiency
class E.
Make sure that the door is
closed properly.
Clean the door seals. Call the
service centre if the door seals
are damaged.
EN 23

Publicité

loading