VONN Lighting RUBIK Serie Guide D'installation page 3

Fig. 1
RECTANGLE: CUT OUT
L12 7/8" x W2 1/4"
(L328mm x W58mm)
1. Cut (12 7/8" x 2 1/4") hole in the ceiling
(Ceiling thickness 1/2" to 1 1/2")
Fig. 3
Green / Ground
Black / Hot
White / Neutral
Power supply
3. Connect fixture wires to building wires
Connect each supply wire with appropriate dirver wire
connector
Installer tip: The fixture features electric low voltage
(ELV or 0-10V) dimming capabilities.
Fig. 5
5. Connect the DC wire. Place DC wire and driver box into
the ceiling
www.vonn.com
Instructions
Dim-gray(0-10V)
Dim+purple(0-10V)
Cable to fixture
Fig. 2
2. Pull building supply wires through
ceilling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 4
4. Place driver box into ceiling
Fig. 6
6. Insert fixture body upward to clip into ceiling
© VONN Lighting,2020